Cytron
Sort by
Show result
  • Dual channel, Bi-directional control motor driver
  • Support motor voltage from  2.5V to 9.5VDC
  • Maximum current up to 1.0A continuous and 1.5A peak (<5 seconds)
  • 5V Output (200mA) to power the controller.
  • Inputs compatible with 1.8V, 3.3V and 5V logic (Arduino, Raspberry Pi, etc).
  • Solid state components provide faster response time and eliminate the wear and tear of mechanical relay
  • Regenerative Braking
  • Speed control PWM frequency up to 20KHz (Actual output frequency is same as input frequency)
  • Dimension: 43mm(W) x 35mm (L) x 14mm (H)
RM14.90
  • Maker UNO X 1
  • USB Micro B Cable X 1
  • LED 5mm Red X 3
  • LED 5mm Yellow X 3
  • LED 5mm Green X 3
  • Breadboard Half Size X 1
  • Dupont 40 Pins Male to Male Jumper Wire X 1
  • Resistor 0.25W 5% (220R) X 10 
  • Resistor 0.25W 5% (1K) X 5 
  • Resistor 0.25W 5% (10K) X 5
  • LDR X 1 
  • Transistor 2N2222 X 1 
  • Finger Adjust Preset 10K X 1
  • 3V~5V DC Motor 130 X 1
  • Miniature Fan Blade X 1
  • Plastic Box X 1
RM49.90
  • Microcontroller : Atmega328P
  • Programming IDE: Arduino IDE
  • Operating Voltage : 5V
  • Digital I/O Pins: 20
  • PWM Pins : 6
  • Analog Input: 6 (10-bits)
  • UART, SPI, I2C : 1
  • External Interrupt: 2
  • Flash Memory: 32KB
  • SRAM : 2KB
  • EEPROM/ Data Flash : 1KB
  • Clock Speed: 16 MHz
  • DC current per I/O Pin 20 mA
  • Power Supply: USB Only!
  • DC Current 5V: USB Source
  • DC Current 3.3V: 500 mA
  • USB to Serial Chip: CH340G
  • Programmable LED: 12 x from digital Pin 2 to 13
  • Built in Programmable Push Button and Piezo Buzzer.
RM29.00